The UPS synchronization has been configured but does not function.

In case a UPS synchronization function operates improperly, the connection or the set-up may be incorrect.
Check the following items.

1. Initialize the set-up for the UPS.
   Confirm the initial set-up by referring to user's manual issued by each UPS manufacturer.
2. Connect the USB port of the product and the UPS directly with a dedicated cable attached to the UPS.
   - Only compatible USB products are to be connected to the product.
   - No multiple connection, for example, via a USB hub, is acceptable, even between pieces of USB compatible equipment.
3. Set on the product as follows.
   Select [Management]-[UPS Sync], followed by clicking [Edit] on "UPS Synchronization Settings".
   Tick "Sync with the UPS connected to the TeraStation."
   

   Item	Set-up
   UPS connection type	(depending on the UPS manufacturer's instruction)
   Shutdown will occur if	[Power outage longer than x-minutes.] or [UPS send low battery signal.]
   How should the UPS behave after a TeraStation shutdown?	[Turn Off]
   UPS Recovery	[Enabled]